MSD Releases New EFI Crank Trigger Kits!

Official Release:

MSD Releases New EFI Crank Trigger Kits!

Holley is pleased to announce the release of new crank trigger kits from their MSD Ignition division! The MSD flying magnet crank trigger is now available with a hall-effect sensor making it the most accurate way to trigger your EFI.

The kit installs easily and uses rigid aluminum mounting bracketry and hardware that will not flex and cause timing fluctuations. Powerful magnets are embedded in a 3/8″ thick aluminum trigger wheel that will send your EFI a clean signal for every firing.

Small Block Chevy

Big Block Chevy

Small Block Ford

  • Same, easy install as traditional MSD Crank Trigger Kits.
  • Most accurate way to trigger your electronic fuel injection (EFI).
  • 3-wire Hall-effect sensor that is less susceptible to noise  interference as compared to traditional magnetic pickups.
  • Available for Small Block Chevy, Big Block Chevy and Small Block Ford!
MSD Ignition continues to innovate with their new hall-effect crank trigger kits for EFI applications. It has never been easier to have precise, high performance ignition control and these new trigger wheels are perfect for your next EFI conversion!
For more information on these products and a complete array of savable high-resolution photos (click image until you reach the largest size, and then right-click the image and click “Save As”), click the links below.
Source :

Holley/MSD

Share this post